Control
The electrical components
are mounted in a closed cabinet located behind the control panel.
The front panel controls includes cutting motor on/off switch,
coolant recirculating pump on/off switch, internal light switch
and emergency stop switch. Cutting motor switch can do rotation
or stop cutting wheel.
Coolant pump is on, coolant is re-circulated and user can check
a cutting area distinctly by internal lamp switch. If the operation
is missed, the emergency switch can stop all behavior.
Users can cutting the specimen simply by pull of the lever arm
during the wheel is rotated. |
Specification
3HP three phase motor,
220V, 60Hz
Table-top type unit with recirculating
coolant
Anti-corrosion coated case
Max. 3,500RPM at no load
Max. 32mm spindle diameter
Max. cutting capacity is up to 70mm
40mm vise capacity
20 liter reservoir
60liter/min flow rate pump
Sealed port for long specimen
T slot bed with double vise type
Easy handle operation with counter force
Safety switch for finishing to cut
Safety switch for door open |
Accessories
Fastener vise : Vise for gripping
fastener and other small parts and positioning them
Consumables
Abrasive wheel
9" ~14" diameter abrasive wheel is available
for soft nonferrous, hard nonferrous, hard steel and soft steel.
Coolant : Water soluble oil based
|
