This machine id designed for the evaluation of lubricants
and the friction and wear properties of materials in dry and
lubricated reciprocating sliding or rolling/sliding contact
conditions.
Application :
This system can do following wear test : abrasive wear, adhesive wear, delamination wear,
fretting wear, scuffing and stick-slip.
Also can carry out standardized tests
in accordance with wear standards, like as ASTM G133, D5706,
D5707, ISO12156-2. |
Technical Spec.
Contact Configuration : Ball on Plate (Point Contact)
Cylinder
on Plate (Line Contact)
Area
Contact
Optional Configuration : Piston-Ring and
Cylinder Liner
ISO
Fuel Test Specimens
Load Range : 5 to 500 N
Temperature Range : Ambient to 700 กษ
Heating
Capacity : 440 W
Temperature Sensor : K-type thermocouple
Frequency Range : 2.5 to 50 Hz
Stroke
Range : 0.05 to 15 mm (8 steps)
Contact Potential : 50 mV
DC signal
Friction Transducer : Load cell
Force Range : - 500 to +500 N
Plate Specimen : 38
mm x 58 mm x 4 mm thick (typical)
Point Contact :
6 mm and 12.7 mm diameter ball
Line Contact : 5 mm
diameter x 15 mm long pin
Area Contact : 10 mm diameter
x 5 mm thick disc
Interface : R&B MUX Serial Link Interface Module
Software : R&B sequence control and data acquisition
software
PC spec.
500 MHz CPU
64 MB RAM
6.4 GB HDD
3.5" FDD
MS
compatible mouse
17" color monitor
RS 232 serial port
Control factor
Frequency
Load
Temperature
Test
Duration
Record factor
Load
Friction
Temperature
Contact Potential
Frequency
Wear
Friction Coefficient |
